Separate names with a comma.
Does anyone have a clear photo of the left hand side of the carb installed with the throttle linkage fitted and the correct return spring and...
I was browsing through Tom Corcoran's 'Shelby Mustang' book, and on pages 36 and 37 there are pictures of a '65 GT350R, showing the interior, and...
My '67 GT350 needs new power steering hoses. I have checked the NPD catalogue, and it lists five pieces (I think I understand where they all go!)...
I have recently had my motor refreshed and have put a few hundred miles on it to break it in. I have started using a bit more throttle...
For the guys on here from NZ - I know this is a long-shot, but some years ago (back in the '80s !) a couple from NZ came over to England and...
When I bought #02751 67 GT350 back in the early '80s, the spare wheel had a Goodyear Polyglass tire on it. At the time I thought it might have...
I've been looking through some old documentation that came with my car ('67 GT350 #2751), and I found the Import Declaration documents from 1974...
Does anyone have any of the following data? Power/torque curve for Shelby-ized 289 Hipo Cd and frontal area (or CdA value) for '67 GT350 I...
Thank you to everyone who has recently helped out with comments and advice that have helped to get my '67 #2751 up and running! Firstly,...
'67 gt350 4-speed, rebuilt the engine to stock spec, and using original 735cfm vac sec carb and manifold. When I built the carb, I set the...
There has been some discussion about cooling fans for '67 GT350s on here before, and the concensus seemed to be that they did not have a clutch...
What's happened to our front page? I liked having all the latest threads from all the forums in one place - it made it worth making a quick...
I replaced my speedo cable the other day because it had melted against the exhaust and was no longer turning the speedo dial. On pulling the...
Here's a question to stretch the forum's knowledge!:confused: What is the paint code or manufactures paint name for the charcoal gray colour...
Took my 67 GT 350 out for a run today - the engine is fresh and I want to get a few miles on before I risk doing any long journeys. I drove...
Ok, this is gonna get a bit boring for some of you, but I have to get to the bottom of this. I need new tires for my 67 350. I am told that...
I took this picture of the original KD marking on 2751 last weekend (using a cell phone - hence the poor quality). The lettering is under the...
This might sound like a lame question, but...:blush: Can anyone direct me to the correct turn signal flasher unit for a '67 GT350? What is...
Can anyone tell me the significance of the #25 grease-penned onto the bulkhead of my '67 GT350 (see attached picture - just above the heater...
I have a rear anti-sway bar that I took from a friend's wrecked Boss 302. I don't remember if it was a '69 or '70 (I know only '70s had them as...
Does anyone have the exact measurement for the brake booster push rod adjustment on a '67 GT350 4-speed? Skid
I plan to do the following to my otherwise stock '67 GT350 - 1) Lower the upper A arms 1" 2) Use stock springs and original Koni shox 3) Fit...
I own 02751 here in England, and I have some paperwork with it that suggests it was shipped out of Palo Alto California around 1972. The...