Separate names with a comma.
When I had my 68 I got a flasher and opened it up and played with the point gap till it got my turn signals to work right.
Buy a small propane bottle and mount a small hose on the end. Then turn the propane on and then you can pin point the leak.
Check your engine oil if you smell a lot of gas in the oil change it . If you get a lot of gas in the oil it will wash the oil of the cylinder...
After you remove the shocks that is all you have to remove. MAKE sure the spring compressor tool is on the spring good. If not it is like a bomb....
You need to rent a spring compressor and once you get the coil spring out Check the spring support on the upper control arm. Remove it and make...
It also does not have the reinforcement on the cowl for the x port brace.
On later 65 Shelby's what emblem is on the door sill scuff plate. And who makes the best scuff plates and emblem. Thank You
Yes, I went 9/9/1999 that was my birthday. We got done with the tour and walked the front door . Parked out front was the first F.I A Cobra they...
Run a wire from the ground side of your battery to the side with the lights are out and see if they work. If they work check for bad ground. If...
The used 2 1/2 rear metallic brake shoes and drums. They used the same K/H calipers as the Mustang excpt they used metallic pads.
[ATTACH][ATTACH]
Are your motor mounts in good shape?
Did you try reversing the wires on the back of the amp gauge. Disconnect battery first.
You just need to get the steel fuel line they used on 66 Shelby and the 715CFM Carb and bracket that holds line at the water pump and a fuel filter.
The site looks good. Nice Job.:thumbup:
Check with Jim at Shelby Parts in Green Bay Wi. :thumbup:
Was the pinch weld on a 65 Shelby painted black. On a late car is the under side of hood black or white. Thank You override
Found this in my key chain box.My sister gave this to me when she sold Fords back in the 70's. It has the Cobra II on one side and the Stallion...
Re: Shelby GT350 carb return spring Hi Bill Years ago i sent the carb out to Holley to rebuild it . When i got it back they put that on...
I have been running a older Pertronix #1281D for years . Never had any problems with it and i also bought the coil to. My Tach works fine....
Re: Shelby GT350 carb return spring Here is a picture of the return spring.[ATTACH]
Felpro makes a double thick valve cover gasket. I use them on my 65 GT350 so my posi lock nuts clear my sand cast Cobra Valve covers.
Very cool, Love those B/FX and A/FXer Comets.
351 W engine are know for valve guides wearing out. So switching to roller rocker arms put less strain on valve train then stock rocker arms. So...
Hi Doug D Elgin has changed some much now and all the towns around. All built up. Good Luck override