Separate names with a comma.
I still have the original documents for 1257. Title application and 1 year warranty from Courtesy Ford. Dan or Jack Bell? Or whoever wants the two...
I just turned on the TV for NASCAR and heard of Mr. Shelby's death. I've owned two of the originals and had the pleasure of meeting him one time...
Got it! Thanks for the clarification. Now, get yourself a new set of points, condenser, rotor and cap. If you've never replaced a set of points...
GCRIV, what did you scrape off of the "leads"? Corrosion? If so, replace the cap and wires (one at a time) and could you please explain how you...
Tommyleea is right about the basic tune up. Most intermittent problems are electrical related and not fuel. It sounds like if you run it hard and...
Re: Fuel pump working or not? Bypassing the fuel filter is only for the purpose of diagnostics. If the engine runs the same with the filter...
Re: Fuel pump working or not? I know this is basic information and it probably has already been mentioned, but in regards to rubber fuel lines,...
I had heard of using propane to find a vacuum leak, but never tried it as propane is heavy compared to air and will settle settle on the ground...
Take a vacuum reading while the engine is running at an idle. Write down that reading, then rev the engine slightly and watch the needle on the...
Re: Fuel pump working or not? GCRIV, in reference to using the carb cleaner. You probably will not see any bubbles when trying to detect a...
mherman, thank you so much for the information on #1257. I looked at the photos and see an Ivy Green w/ white stripes 66. There is only one...
Re: Fuel pump working or not? Ok, now I'm really suspicious of the new fuel filter. This filter reminds me of the tube of caulk I've been...
Re: Fuel pump working or not? "inline clear filter that you installed" keeps being mentioned. Is it possible that the filter was installed...
GT350KID, I know what you mean by trying to find the current owner of the car you had so much history with. I too have original documents on...
That's horrible, so sorry to see that happen. It reminded me of my 65 fastback 427 Galaxie I had back in the sixties. The engine was just...
Uh oh, this post is reminding me to go out and buy a new turkey baster before my wife finds out what I used hers for.
I think he mentioned, the engine is out of the car, rotating the engine is going to have to be with the crank bolt. I think I would still just...
I use an ultrasonic and one of those little pink denture tablets. Sorry!::rolleyes:
Yes, rotate until both intake and exhaust valves are in the closed position and make sure the timing marks on the crank a lined up. On valve...
You didn't mention what year or make of engine you are working on, but if memory serves, I would remove the valve cover on the side of the engine...
Wow! What a great find. Those are the wheels that were on my 66GT350 and my 67GT500. Someone is going to be very pleased with their purchase. Mike
I'll bet some of those people don't look like that now.
What a great photo of your beautiful 68 GT350 with my favorite colors. I couldn't help noticing the interesting rock formation in the background....
Also, check for loose or worn butterfly shaft on the primary side. I don't know if it would affect starting but it would affect the idle by...
If it wasn't for Mustang's, I would guess there would be no GT350 or GT500's. I'd say, stay tuned to this forum and you will gain a lot of...