Separate names with a comma.
Thanks, you are right, they are 7", somehow they just looked wider sitting on the floor.
That's a very nice car, congrats! I went a different route, I had an MP3 plug istalled into the back of my original AM/8-Track unit, and then ran...
I ordered some new 10 spokes from Branda for my '68 KR. They only came in 15X8. Now I am looking at them and worried they are way too wide to...
You're welcome, I find these kind of small details to be very interesting and informative. As I mentioned before, I have been away from Shelbys...
I blew out both ends with compressed air, and used a .38 caliber wire brush to clean up the holes into it, and vacuumed it out. Then I reseated...
Wow, now that is a good idea if you have the engine out. Too bad it wasn't done when the engine was overhauled and painted by the previous owner....
Thank you very much!
Having now obtained the proper C80F-9510-AB carb for my KR, I am trying to figure out the choke tubes hookups. My previous carb, a Holley 4779,...
OK, thanks very much for all the tips, I will be in touch on the harness too.
Thanks very much, finally found it. I was looking for a can or rectangular type, this was a black case solid state flasher unit from Cougars...
I am sorry, but I cannot locate the turn signal or emergency flasher cans under the dash of my '68 Shelby. I can hear the turn signal one, but I...
OK, thanks very much!
OK, thanks. But do you know where that short can shaped sender with a rubber boot over it is located on the engine?
I understand the original SW oil pressure gauge on the '68 Shelby was an electrical unit, hooked to a sending unit on the engine. Where was the...
Re: 67 Shelby Windshield Question I have used those Permatex kits for cracks and impact circles for the last several years. I fixed one as large...
Thanks, yes I have torqued them to 100 Ft.lbs. with the tapered lug nuts, as the specs said to.
Thanks for the info. I guess that would explain why Branda only sells a tapered lug nut for '68 10-spokes he calls "correct" style.
Sure, here it is. The tapered lug nut goes about 1/2 way down into the taper on the hole of the wheel.
My wheels are not counter-sunk like the ones with the washers.
This is the lug nut I have, according to Branda's description of the part, this is the "correct" type. Branda has no lug nuts with washers for...
OK thanks. I did see the webpage on 10-spoke by coralsnake, but it doesn't mention a tapered lugnut like I have. The seat on the wheel where the...
Does anyone know if the typical aftermarket Shelby 10-spokes have a beveled lugnut, or a flat bottom one that uses a washer? The guy at the tire...
I notice he also has the infamoous delay relay, not too bad a price, compared to the last time I got an NOS one for my '68 1/2 CobraJet about 10...
I have decided to use Pirelli P4000 Touring radials. They are the only Z rated tire in that size, and it seems many KRs actually had blackwalls...
Thanks very much for making it an easy choice. In looking at prices, I could have predicted it :D
