Separate names with a comma.
The long ones like those pictured were for duel exhaust cars. The short ones were for single exhaust cars. Also the ones with rounded corners like...
I beg to differ. It is a very nice compliment to think it is untouched.That is my old car and I touched it . I had the engine out and did all the...
Yes to Eric's question. Mike, I assume you mean oil filter instead of fuel filter canister. The short fat one is the one that is technically...
Re: '67 GT500 fuel pump oil cooler line clearence Eric and all, here is a picture taken from below looking up at fuelpump canister. Notice the...
dusty NOS correct fuel pump with correct autolite canister.
It certainly benefits all enthusiasts like myself searching for the truth whatever the truth might be ,that you found some pretty substantial...
Rod ,All the times we have talked over the years and all the times I have helped you correct little things on your car over the years most...
Don't asume all the early Shelby vin tags were hand engraved . #1 and #8 were hand stamped. I used to own #8 and #1 is in the Bat Cave with the...
Unless you are going to run the tar out of the car and vintage race the car or something, anything more the the original hydro shocks would be...
I will take some pictures of the oil cooler lines and the special oil filter that are on a car in my collection. It will probably be Monday...
All of the 1967 Shelby GT500 used the carter pump button top with the canister (marked Autolite not Fomoco). The assembyline and early service...
Clove9414, it sounds like you have a nice car. I would suggest going for the repro tires . The reason you see the Speedways used on KR's almost...
In the SAAC DIV II or MCA trailered concours since the tires are the same size ,MFG and Bias Ply construction there are no points deduction ....
If you are going to drive your car put on some good Goodyear radials . The Goodyear speedways are junk for driving on compared to even the...
Bo, on the prop rods at least some of the port hole hoods also used springs I believe all the metal understructure hoods used springs . The all...
All of the historical photos I have seen with the port hole hoods and wire mesh are body color as well as personal observation . I have seen the...
There are also some GT500's with K code.
I would check out the accellerator pump in the carb . Wore out spring or leaking. Not squirting enough when you press on the gas . My 2 cents .The...
Jim, the factory Shelby tail light harness is as I described in the other post the regular Mustang harness it CONNECTS to has the weave material....
The picture of the 67 GT350 engine compartment submitted for use on the NVSAAC website is not restored very factory correct and I would not use it...
I can tell from the picture that the webing is even wrong. Stuart at Python does the best job I have seen and I am very picky.
I just open my Oct 07 edition of Mustang times and on page 42 is a picture of a smallblock Cobra with the same duel four intake and the carter carbs.
It was a over the counter intake . I have seen a few 289 Cobras with this upgrade. The set up came with special Carter carburators. Too bad those...
The 2/12 backing plates used on 67 /68 Shelby were used on galaxie station wagons as well as others the 2 1/2 backing plates are required to use...
Of course I meant over 1 thousand . Like 1800,1900. I am sorry I was not more precise. I have a bad habit of using short cuts or slang when...
