Join Shelby Forums Today

Build-Sheet 70 Shelby

Discussion in '1965-1970 Shelby Mustang GT350 & GT500' started by Kiwi-Shelby, Feb 11, 2008.

  1. Kiwi-Shelby

    Kiwi-Shelby Member

    Posts:
    16
    Likes Received:
    0
    Joined:
    Feb 6, 2005
    Location:
    New Zealand
    Hi there...can anyone advise if the 69-70 Shelbys had more than "one" "build-sheet"??....many years ago I located one behind the drivers seat taped to the floor under the carpet...although I have a photocopy I have misplaced the original...I have been told that sometimes there were "two" buildsheets...where on the car would another location be??....any information much apprieciated...Martin (New-Zealand)...:)
     
  2. TLEA

    TLEA Well-Known Member

    Age:
    66
    Posts:
    887
    Likes Received:
    11
    Joined:
    Oct 17, 2005
    Location:
    Warwick, Rhode Island
    Every car is different but my friend just found 3 when tearing down his 69 350
     
  3. tesgt350

    tesgt350 Well-Known Member

    Posts:
    1,093
    Likes Received:
    2
    Joined:
    Feb 10, 2006
    Location:
    I am in my own little World
    Under the Back Seat between the Foam & Springs, up under the Dash wraped around the Wires, Behind the Interior Rear Quarter Trim Panels are a few places I have found them.
    David.
     
  4. K.Wyman

    K.Wyman Member

    Posts:
    19
    Likes Received:
    0
    Joined:
    Feb 22, 2007
    In my 69GT500 I have been able to locate 3 sheets.
    1.underneath driver's seat,between the springs and foam
    2.under carpet in back seat(right side of car)
    3.under carpet where driver's feet go
     
  5. Kiwi-Shelby

    Kiwi-Shelby Member

    Posts:
    16
    Likes Received:
    0
    Joined:
    Feb 6, 2005
    Location:
    New Zealand
    Thanks for the replies....I will check all the areas mentioned....regards..Martin:)
     
  6. Snakepit

    Snakepit Well-Known Member

    Posts:
    843
    Likes Received:
    12
    Joined:
    Jul 3, 2005
    Location:
    Central Calif
    Martin ... at each plant there were more than a dozen build sheets printed (for the body and all the sub assemblies) At Dearborn some of these copies were attached to the subassemblies (unlike other plants) to identify the car that the assembly was for. Because of this there si a great opportunity to find one or more.

    Other places

    - Attached to the inner fender panel (normally long gone but you can often find the tape or shadow where it was attached)

    - The back side of one of the door panels

    - Thrown in behind the interior quarter panels
     
  7. Kiwi-Shelby

    Kiwi-Shelby Member

    Posts:
    16
    Likes Received:
    0
    Joined:
    Feb 6, 2005
    Location:
    New Zealand
    Thankyou.....the information is much appreciated...I will check behind rear quarter trim and door panels....regards...Martin:)
     

Share This Page