Separate names with a comma.
thanks I'll do that
Has happened to me in the past, torque was bad and transmission would lock up, thus stalling the motor while on the brake. Check your carb again...
not knowing all the symptoms if your car is manual it seems that your float bowls may be adjusted too low, if it is automatic and nthe float...
does any one know where I could get a fan clutch rebuilt? or is anyone selling a good clutch for a 67 gt500. I have the original but it seems to...
Thanks for the info, great help
Intake is just sitting, not bolted nor finished, as are the valve covers, I do not have lift hooks, which at this point I am less concerned with...
I see but a portion of the machined pad where the dipstick is located and also below is not covered by the gasket. So does this stay clean...
If it is working, and could be cleaned up nice, I would go ahead. It also depends on the use of the car. Just an opinion
Great info, Thanks!
So the gasket and the adapter were installed after painting the motor.. Was the pad painted or was it left machined surface? Thanks for the help.....
I am currently restoring an original 1967 gt500 intake. I am missing the tear cover which seals up the big hole at the rear of the intake. Does...
Does anybody know How was the oil filter adapter mounted? Before motor got painted, meaning the machined surface of the block which is still...
