Join Shelby Forums Today

Shelby Charger chassis fab question

Discussion in 'Shelby Dodge' started by deathek, Oct 1, 2011.

  1. deathek

    deathek New Member

    Posts:
    3
    Likes Received:
    0
    Joined:
    Sep 25, 2011


    I am wanting to customize my shelby charger,and was wondering if anyone nows of a frame from another car that would fit under it to hold a v8, i have did research, and an 80's v8 mustang is only a few inches wider then my shelby charger. if any one has any suggestions i would be appreciative. and please dont reply with hate mail or hate-replies, cause it is immature, this is an honest question. thank you
     
  2. mrmustang

    mrmustang Well-Known Member

    Posts:
    512
    Likes Received:
    16
    Joined:
    Dec 23, 2004
    Location:
    Greenville, SC
    Sorry,no bolt in chassis that will work. Anything you do will require custom fabrication.
     
  3. deathek

    deathek New Member

    Posts:
    3
    Likes Received:
    0
    Joined:
    Sep 25, 2011
    so will the 80's gt sub-frame work with some fab work done to them? or would it be just as hard to make a full chassis? i have made chassis's before with my father. ( both were full 2 x 3, on a vega, and second was a vega gt.) i do want to get into a little racing, so ill prolly just go with making a chassis. but any info u could shed would be nice. like a v8 rear-end that will fit decent, i do know the mustang gt's around 84 have a body width of around 3 inch's wider then my shelby.

    :alarm::lmao:
     
  4. mrmustang

    mrmustang Well-Known Member

    Posts:
    512
    Likes Received:
    16
    Joined:
    Dec 23, 2004
    Location:
    Greenville, SC
    It's a custom install, so you get to be the guinea pig and the person to document your discoveries.
     
  5. 67GT500#2100

    67GT500#2100 Shelby Forums Pit Crew

    Age:
    56
    Posts:
    1,398
    Likes Received:
    1
    Joined:
    Sep 1, 2005
    Location:
    Near Michigan International Speedway
    I think direct connection used to make a kit for this type of swap. I remember seeing a couple done back in the nineties.
     
  6. 67GT500#2100

    67GT500#2100 Shelby Forums Pit Crew

    Age:
    56
    Posts:
    1,398
    Likes Received:
    1
    Joined:
    Sep 1, 2005
    Location:
    Near Michigan International Speedway

Share This Page