What are the size of the stripes on the 1967 GT500 Super Snake? See attached note below from the Charlie the car's owner. (Thanks to Colin Comer for assistance on getting this info.)
Also in the October issue of Mustang Enthusiast magazine, (pgs. 64-67) is an article on a 1967 Mustang restomodded into a copy of the 1967 Super Snake painted in red with white Super Snake striping. A very nice car looking car powered by a stroker FE engine based on a Shelby Enterprises aluminum 427 engine block.
Jim Seisser
-----Forwarded Message-----
From:
Clill8567@aol.com
Sent: Sep 8, 2005 3:56 PM
To:
ecj@peoplepc.com
Subject: Re: Fw: Re: 1967 Super Snake - Stripes
Hi Jim. As Colin said the car is on a truck somewhere but the stripes are .... Center is 10" and outside stripes are 3" with 2" spacing between them and the center for a total of 20". Same from front to back with no taper. That is going from measuring a couple months ago for someone. I will double check when it gets back but I'm pretty sure that was it.
&n bsp; &nbs p; -Charley
________________________________________ PeoplePC Online A better way to Internet
http://www.peoplepc.com
September 9th, 2005, 12:10 PM
Similar Threads
Linear Mode
