Quote:
Originally Posted by 2dragpac500converts
Here is pic of side view. I did seam seal pinchweld but doesnt show that well because of overspray.
|
The sealer would have have normally been applied around the floor brace as shown in the picture at San Jose and because of the angle the paint was applied there is rarely (from my observations only) any paint in its general location (pinch weld formed a pretty good spray mask)
Quote:
Originally Posted by 2dragpac500converts
I dont know what to do about exhaust h-pipe .I almost think i should start over and have a exhaust shop make something closer. Do you guys know of anyone besides branada that has a correct one?
|
Though Jim Cowles mad/had them.
You might consider just replacing the H pipe. Clamp it to the rest of the system you have (looks like you would need to replace the long sections as they are formed incorrectly) and remove the muffler clamps and weld the pipe at those locations. Not sure if any one is making good looking resisnators currently