[Bob Gaines]

Originally Posted by 2dragpac500converts

Here is pic of side view. I did seam seal pinchweld but doesnt show that well because of overspray. I dont know what to do about exhaust h-pipe .I almost think i should start over and have a exhaust shop make something closer. Do you guys know of anyone besides branada that has a correct one?

I think there is no better alternative but to start over in regards to the H pipe. It is not a big job. Jeff provided a excellent picture to go by . It is a relative simple design. If after showing that picture to a muffler shop and they felt they might have a problem duplicating such a simple design you would have no business letting them close to your car. Now saying that of course whatever shop you use would need to fit the H pipe to the individual car for best fit. It would be too much to expect that a H pipe could be made up from a picture and have it to fit perfectly with out the car it was going on. I have a shop that makes them up for me but I always provide the car for the best fit. Back in the day they were made in a jig in mass and whether they fit or not (exhaust leak) they were installed .