Quote:
Originally Posted by 2dragpac500converts
They are installed. I gave a couple of extra shots of underside let me know if there is anything obvious that is wrong
|
First these are meant in a friendly way and in the spirit of sharing. Some are as much questions/thoughts as right or wrong comments
Secondly it very easy to see you have spent allot of time working on this project... nice work, it shows.
And lastly I have to commend you on offering up your work and efforts to input.
1- What is the finish on the welded in rear end bumpers? Hard to tell from the angle.
2- I would have added the 1/2" wide chalking on the bottom edge of the rear trunk drop to quarter panel joint (inside surface)
3- Not sure what number car this is but , if it was one of mine, I would ahve used stripes rather than spray identifiers on the rear springs.
4- Was the "921" something you found on your car? Same goes for the yellow dots on the bottom of the rear shock/spring plates.
5- Is the wheel well sound deadener over the body color??
6- Did you do the pinch weld black out? Can't make out any over spray on the bottom of the car.
7- Would lighten up the finish on the rear spring clamps. Springs would have been dark heat treated in look and the clamps a lighter natural bare steel
8- H pipe looks like its clamped to the adapters and originally there would be no clamps at the rear of the mufflers
9- Does the gas tank have a drain?
Again, nice work. Take or leave what every you want from my comments and questions