![]() |
||||
|
||||
|
|||||||
|
||||||||||
| 1965-1970 Shelby Mustang GT350 & GT500 Shelby Mustang Talk |
![]() |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Re: 65 Grill Emblem
Hi,
Do you have the C4 or C8 emblem? The C4 has much thinner pins on the back than the C8 and consequently use a different type of nut. My car 5S275 has the C4 and I have a round washer towards the mesh of the grill and locked by rectangular spring loaded nuts of the push type. Of course, there are 4 of each. Hope it helps, Texas Swede |
|
|||
|
Re: 65 Grill Emblem
Hi,
I just measured the washers on my car #275 but there are no guarantees they are the original. Anyway they have 1/2" diameter. I bought the NOS C4 in Carlisle about 8 years ago. Don't remember if I had another C4 or not on the car before adding this one. Texas Swede /Bo |
|
|||
|
Re: 65 Grill Emblem
Yes, as said, I am not sure if the washers shall be there or not.
Looked in some magazines from 1965 with pictures of the grill mesh and the emblem up front and it looks like there are washers behind the ones you can see. These cars in the 65 magazines were very early so it's possible that they didn't use the washers on later cars. Texas Swede |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower grill on Shelby GT | maddog23 | 2007-2010 Shelby GT500, Shelby GT-H, and Shelby GT Forum | 14 | December 10th, 2007 08:47 PM |
| 1967 Trunk Emblem Question | MRP_GT-350 | 1965-1970 Shelby Mustang GT350 & GT500 | 2 | November 18th, 2007 03:06 PM |
| 67 grill question | firestanggt | 1965-1970 Shelby Mustang GT350 & GT500 | 4 | October 12th, 2007 10:01 AM |
| 67 GT500 emblem placement | Lugnut | 1965-1970 Shelby Mustang GT350 & GT500 | 2 | October 27th, 2006 07:19 AM |
| 2007 GT500 Tail Emblem | rshelby | 2007-2010 Shelby GT500, Shelby GT-H, and Shelby GT Forum | 14 | September 3rd, 2005 04:09 PM |